With these frigid temperatures, comes extra maintenance for our homes which can be a headache. Inside every home, there will be a series of pipes that are vulnerable to freezing throughout the lower temperatures. If a pipe freezes, it’s important to get someone out to try and fix the problem before the pipe eventually bursts. If that occurs, there should be repiping specialists that can replace any burst pipes, allowing your home to continue using the water. Before you need your pipes replacing or repairing, there are steps that can be taken to try and reduce the chances of your pipes freezing. Here are some simple steps you can take to avoid having any piping issues on your hands.
(from the American Red Cross)
Why Frozen Pipes Are a Problem
Water expands as it freezes.
This expansion puts extreme pressure on whatever is containing it, including metal or plastic pipes. Pipes that freeze most frequently are those that are exposed to severe cold, like outdoor water faucets, swimming pool supply lines, water sprinkler lines, and water supply pipes in unheated interior areas like basements and crawl spaces, attics, garages, or kitchen cabinets. If your pipe does freeze, you may have to get someone like sagewater.com to come out and replace it for you.
Also, pipes that run against exterior walls that have little or no insulation are also subject to freezing. A 1/8-inch crack in a pipe can leak up to 250 gallons of water a day, causing flooding, serious structural damage, and the immediate potential for mold.
In the US, frozen pipes cause significant damage every year, but they often can be prevented. Taking a few simple steps, even now, may save you the aggravation and expense.
There are three common causes of frozen pipes:
- Quick drops in temperature
- Poor insulation, and
- Thermostats set too low.
There are a number of preventative steps you can take to keep your pipes from freezing:
- Check the insulation of pipes in your home’s crawl spaces and attic. Exposed pipes are most susceptible to freezing.
- Heat tape or thermostatically controlled heat cables can be used to wrap pipes. Be sure to use products approved by an independent testing organization, such as Underwriters Laboratories Inc., and only for the use intended (exterior or interior). Closely follow all manufacturers’ installation and operation instructions.
- Seal leaks that allow cold air inside near where pipes are located. Look for air leaks around electrical wiring, dryer vents, and pipes, and use caulk or insulation to keep the cold out. With severe cold, even a tiny opening can let in enough cold air to cause a pipe to freeze.
- Use an indoor valve to shut off and drain water from pipes leading to outside faucets. This reduces the chance of freezing in the short span of pipe just inside the house.
- A trickle of hot and cold water might be all it takes to keep your pipes from freezing. Let warm water drip overnight, preferably from a faucet on an outside wall.
- Keep your thermostat set at the same temperature during both day and night. You might be in the habit of turning down the heat when you’re asleep, but further drops in the temperature – more common overnight – could catch you off guard and freeze your pipes.
- Open cabinet doors to allow heat to get to un-insulated pipes under sinks and appliances near exterior walls.
If Your Pipes Do Freeze…
Don’t panic. Just because they’re frozen doesn’t mean they’ve already burst. Here’s what you can do:
- If you turn on your faucets and nothing comes out, leave the faucets turned on and call a plumber (like Paul The Plumber – paultheplumbernh.com/nashua-plumbing-heating-cooling/). They will advise you what else to do when you call, as well as coming out to fix it.
- If your house or basement is flooding, turn off the water valve and immediately call 911. Once the danger is sorted you can get someone like ServiceMaster of Lake Shore to repair any water damage.
- Do not touch or use electrical appliances in areas of standing water due to electrocution concerns.
- Never try to thaw a pipe with a torch or other open flame because it could cause a fire hazard. Every year, many building fires are caused by people trying to thaw frozen pipes. All open flames in homes present a serious fire danger, as well as a severe risk of exposure to lethal carbon monoxide.
- You may be able to thaw a frozen pipe with the warm air from a hair dryer. Start by warming the pipe as close to the faucet as possible, working toward the coldest section of pipe.
- Again, if your water pipes have already burst, turn off the water at the main shutoff valve in the house; leave the water faucets turned on and call 911. Make sure everyone in your family knows where the water shutoff valve is and how to open and close it. Likely places for the water turn-off valve include internal pipes running against exterior walls or where water service enters a home through the foundation.
- If you will be going away during cold weather, leave the heat set to a temperature no lower than 55ºF.